跳到正文
Ars Technica· Jonathan M. Gitlin·· 2 小时前AI 评分35

加州 DMV 叫停 Waymo 高速自动驾驶,Waymo 限制车队只走地面道路

Waymo has stopped its robotaxis from driving on the freeway—here’s why

AI 导读

Waymo 因自动驾驶软件在高速上以较高速度驶入施工区,被加州 DMV 要求立即停止在加州高速公路上行驶,直到能证明车辆不再对公共安全构成紧迫危险,目前车队被限制在地面道路。

正文 · 原文

Waymo is currently restricting its fleet of robotaxis to surface streets after getting into hot water with California over its cars' driving behavior on highways. Specifically, the software tends to drive into construction zones at speed. As first reported by the San Francisco Business Times, this behavior actually drew the ire of California’s DMV earlier this month, which ordered Waymo to stop driving on Californian highways immediately and until it can convince the DMV that its cars no longer “pose an imminent hazard to public safety.”

This is not Waymo’s first run-in with this problem. In Arizona, Waymo robotaxis did not recognize ramp closure signs on six occasions in Phoenix in April and entered construction zones. A month later in California, seven Waymo robotaxis entered lanes with active construction. In June, Waymo recalled the almost 3,800 robotaxis capable of highway driving. That problem led Waymo to stick to surface streets only in California after the May incidents until late July, when the robotaxis resumed highway operations.

In early July, Waymo told the National Highway Traffic Safety Administration that it began updating the robotaxi software to a version that “improve[s] the recognition of freeway construction zones, more appropriately prioritize[s] construction zones over other freeway hazards, and reduce[s] speed when the AV detects that it may be in a construction zone.”

Read full article

Comments

来源:Ars Technica · arstechnica.com